Плата (модуль) керування навантаженням З РЕВЕРСОМ (двигун, вентилятор...) 433MHz DC12V 3 А бездротовий із пульт

Плата (модуль) керування навантаженням З РЕВЕРСОМ (двигун, вентилятор...) 433MHz DC12V 3 А бездротовий з пультом ДК Wireless Remote Control

Рабочая частота: 433MHz.
Аналітер: 1527 Learning Code.
Діапазон робочої напруги: DC 3.6...18 V.
Споживаний струм (режим очікування): <5mA.
Максимальне навантаження: DC 3A.
Receive sensitivity:<-108dB.
Дальність дії пульта: 50 м (у межах прямої видимості).
Частота (Transmission Rate): 10KHz.
Frequency Deviation: ±0.2MHz.
Модуляція: ASK (superheterodyne)
Розміри плати: 30*13*5 мм
Допустима кількість прив'язок пультів: 4
Рабочие режимы (Working mode): Momentary, Toggle, Latching Mode+stop, clear code
Навчання (прив'язка пультів): кнопка на платі (Learning Button)
Діапазон робочих температур: -20...80 С.

Комплектація
 - плата (модуль) керування навантаженням — 1 шт.;
 - пульт ДК 433 МГц — 1 шт.;

#6580

Програмування пультів:

Operation method:

Clear the code: (Before switching the mode, you must first clear the code)
Press the learn code button 8 times, and the LED goes out. LED flashes 5 times, clear OK. (If you need to change the working mode of the same remote control, please clear the code before learning)
Learn to code:
1. Jog: Press the learning button once, the module LED light will turn on once, enter the learning state, the led light will turn on, use the remote control to press the button to match the code, the led light will flash three times (it will not light up in the learning state), continue to press The second button is to pair the code, the led light flashes three times, and the code is successfully clicked. (The first button is forward jog, the second button is reverse jog)
2. Self-locking: Press the learning button twice, the module led light will turn on twice, and the led light will turn on after entering the learning state. Press the key on the remote control to match the code, the led light flashes three times and turns on (it will not light up in the learning state) Continue to press the second button to pair the code, the led light flashes three times, and the self-locking code is successful (the first button is forward rotation and self-locking (press the second button to stop), and the second button is reverse rotation and self-locking)
3. Interlock + stop function: press the learning button three times, the module led light will be on three times and off, the led light will be on after entering the learning state, press the key on the remote control to pair the code, the first time the key is pressed to learn the forward rotation, press the second key Learning is reverse, the third key is to stop, the LED light flashes three times after learning, the interlocking code is successful (the first key is forward, the second is reverse, and the third is stop).
4. Clear code: Press 8 times to clear the code.